the factory ships guns with one mag.

 

thanks for asking this... i'll be a new P-32 owner next week! right now i'm reading through the posts in this forum

regards,

willie
on the Gulf of Mexico

 

willie
on the Gulf of Mexico

Aka, The 3rd Coast.

 

While we’re on the topic of P 32 mags, I was looking at aftermarket magazine pinky extensions and was interested in the NAA Guardian mag extension but it’s out of stock. So I found a mag on eBay used with the extension and with shipping it was $16. Considering NAA gets $10 just for the extension I was good with this.

The front of the Guardian mag is more rounded than the P32 but it only took 30 seconds with a round file to reshape the extension. It doesn’t need to be perfect, just enough to allow it to lock up to the NAA retention plate. The flat Kel Tec P 32 mag floor plate & retention plate even fits the Guardian mag.

 

While we’re on the topic of P 32 mags, I was looking at aftermarket magazine pinky extensions and was interested in the NAA Guardian mag extension but it’s out of stock.

i just went thru that drill... the Pearce mag extension for the Ruger LCP fits the bottom of a .32 acp NAA Guardian mag to a 'T' - quite easy to pop off the NAA extension with a toothpick, then slide on the Pearce extension - which seems a bit beefier...

*but* it does not work! on the other hand, with a bit of sanding, the Pearce LCP grip extension does work with the P-32's magazine!

i'll also be picking up a Guardian this week - seems like it's a long way from Utah to down here in the near Tropics...



willie
on the 'peninsula on a peninsula' on the Gulf of Mexico

 

I use the Pearce extensions for my Glock and Shield mags, they work well, good fit. I think Pearce lists the same extension for the P 32, NAA and Beretta Tomcat .32

I also ordered a Garrison grip extension. It’s 1.5” long so too big for pocket carry but wanted to try one for range use since I wasn’t interested in the 10 round extended mag.