Community for Kel-Tec Shooters banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
397 Posts
If they do .Then you have a problem that needs corrected.

I run wolff 13lb recoil springs in my 380 KT and 32 . But I do because I shoot a lot of hotter ammo in them . Not because of a feeding problem. Never had one problem with mag springs in my 32/380 or PF-9

What kind of feeding problems are you having . Maybe a rough feed ramp and needs polished . easy to do. Doesn't need to be a mirror polish Gunsmiths do that to show they did something not because the mirror finish needed.

P-11 feeding problem can also be owner operator also. These little 9mm do have a bit of recoil
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #3 ·
Thanks for the reply, The problem was my p11 would not feed hollow points, so I did just finish sanding a little and polishing a high spot on my feed ramp, that did take care of feeding hollow points.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top