Will P3AT and P32 fit in same holster

Discussion in 'P-3AT' started by rkrk, Nov 15, 2009.

  1. rkrk

    rkrk New Member

    9
    Apr 4, 2009
    There is a kydex holster that someone on another board has made using the P32 as a guide. Do people think the P3AT will fit. From the Kel-Tec website there are only small size difference between the two models.

    Thanks in advance
    rk
     
  2. TxCajun

    TxCajun Administrator Staff Member Supporter

    Sep 7, 2004
    Texas
    It's hard to tell and depends on how form fitting that particular holster is.  With leather, typically, you can stretch a P32 sized holster to P3AT.  Kydex is usually tight fitting and less forgiving.  It can, to some degree be heated and reshaped/adjusted.
     

  3. burley

    burley Active Member

    Nov 26, 2006
    Kansas
    You'd have better luck going w/ a P 32 into a P3AT holster,not sure you'll open it up enough the other way around. I'd pass if it cost ya, if free give it a try. I carry a 1st Gen P 32 in a K&D 2 'n 1(leather) made for a 2nd Gen P3AT,fit is fine.
    I have a Grandfather Oak Kydex for a P3AT that the P 32s (1st & 2nd Gen ) both work in but ,I stuck a pc of 'Ape Grip' in it to take up slack. I have another Kydex made for 2nd Gen P 32 and a P3AT won't fit at all.