Community for Kel-Tec Shooters banner
1 - 4 of 4 Posts

·
Registered
Joined
·
935 Posts
Discussion Starter · #1 ·
I was looking through my bag of P3AT / P32 parts and saw I had a couple of the belt clips and one steel pin bolt. I was going to put it on my P32, but the female threaded end of the pin is chewed up enough where it won't allow the screw to go in. I must of had a hard time getting it off the P3AT I had years ago. I'd rather just buy another bolt even if it's something from a hardware store. If anyone has any ideas of something that would work I'd appreciate it.
 

·
Registered
Joined
·
935 Posts
Discussion Starter · #4 ·
excellent move there guy.
Thing is when I last bought pocket clips for the P32/P3AT (many years ago) you had to buy the entire clip just to get a pin. I don't know when they started selling the pins seperately, but I bet they did after enough people asked for the just the pin alone. Crazy thing is the pin with bolt is only $1. They actually sent me two, one totally blued and another with a stainless bolt.
 
1 - 4 of 4 Posts
Top