Community for Kel-Tec Shooters banner
1 - 5 of 5 Posts

·
Registered
Joined
·
53 Posts
When I first got mine the handle was very difficult to remove and install. It seems to have broken in over time as I disassembled and reassembled for cleaning. One thing to note is that I do have to pay attention when reassembling, the handle has to be aligned "level" so that the bottom tab goes through the slots on BOTH sides of the bolt carrier group. Other than that I would expect yours to break in with use like mine did.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top