Community for Kel-Tec Shooters banner
1 - 3 of 3 Posts

·
Registered
Joined
·
475 Posts
Discussion Starter · #1 · (Edited)
I sent a note to Talon Grips and they said that they make grips based on the popularity of the gun. Trent at Talon said I could sumit a request for the RDB grip wrap. He also mentioned I should tell others about the request form.

Here is a link to Talon Grips grip request form.

http://talongungrips.com/grip-request.html

Everyone - please send a request to Talon Grips to make a grip wrap for the RDB. If enough people send in a request Talon will make a grip wrap for the RDB. I've sent my request in.

Trent also said that the closest they have right now would be wraps for the KSG or the CMR/PMR. I have the KSG and it looks close. If anyone has both the RDB and the CMR/PMR please compare the grips to see if they are the same.
 

·
Registered
Joined
·
475 Posts
Discussion Starter · #2 ·
I made some measurements of both the RDB grip and the KSG grip. They appear to be the same. If so, the KSG grip wrap should fit the RDB. The only difference would be that the KSG grip wrap has the two holes for the take-down pins.

I'll order one and let you know.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top