Community for Kel-Tec Shooters banner

1 - 9 of 9 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
Hello,

I did a quick search for this and didn't find anything, so I just wanted to post that the screw size for every screw that holds the sub2000 receiver and stock forend together is 8-32 x 3/8". I replaced all my screws with stainless steel hex screws (i have a chrome subbie, so it looks pretty good this way.) If anyone wants to do the same it requires 22 screws and 4 #8 washers.
 

·
Registered
Joined
·
3,793 Posts
' And they were Kung-Fu fighting ' [ me doing the cabbage patch ]:)

Looks sharp AND classy. I think it would be a challenge to match accessories to the HC model, good job t. Possibly you could do the WallyWorld cheek piece on the buffer tube?
 

·
Registered
Joined
·
28 Posts
Discussion Starter #9
Thanks for the compliments. I just installed a Red Lion Precision Forend, so I will have to do the same thing all over again with different sized screws.
 
1 - 9 of 9 Posts
Top