[dvonella]

So I am looking to put a quality sling on my SU-16 with the Zhukov handguard, I plan on taking advantage of the Mlok on the handguard to install a QD up front but I have no Idea how to go about installing a QD on the stock, I would like for it to be somewhere around the grip so that I can run single point as well... do you all have any recommendations or pictures of what you have done?

 

[mtacm]

I don't know for sure if this will work, but I haven't found a whole lot on sling options in my searches. I found the one where the guy used an Uncle Mike's kit for a front barrel attachment and then a KNS screw and pin w/ a QD end for the rear.

I thought about removing one of the screws just above the takedown pin and replacing w/ something like this for the rear point. https://smile.amazon.com/dp/B005Q0B...TF8&colid=1DO5UB7P21ODK&coliid=I1JRO1NZ7G66VD

You could probably use for a single point sling.

 

[imhminhi]

SU 16CA setup that works well for muzzle down carry. Found all the parts on Amazon.

a) Noveske Flush QD Sling Mount 05000471 (requires a 1/2 in hole in the stock, careful to drill hole to not interfere with magazine storage into the corner of the stock to get it rest properly on shoulder, use a thin SS washer with the square fastener to better spread the point load into the stock)
b) 2 Point Sling With FAST-LOOP Adjuster by STI - Optimum Design Duty Sling - Heavy Duty 1.25 inch MIL-SPEC Webbing
c) 2X QD Sling Swivel