Community for Kel-Tec Shooters banner
1 - 6 of 6 Posts

·
Registered
Joined
·
0 Posts
Discussion Starter · #1 ·
at the range today shot about 3 mags threw my p3ata and then nothing. pull the trigger nothing so i thought it was a crappy round pulled the slide back and pulled the trigger nothing happin the hammer does not fall . has this happen to anybody else ?
 

·
Banned
Joined
·
4,317 Posts
Yes, an occasional occurance. Your trigger spring has slipped out from it's groove in the bottom of the trigger bar.
 

·
Registered
Joined
·
5,028 Posts
does the hammer draw back, but not far enough for it to fall?

If so look at the pin behind the trigger.  If this pin drifts out, it will cause the above.  given the pin is in an ackward position, but it has been possible for some to push it back in.

If you look through the FAQ/VIP there is a past post with this link
http://www.1bad69.com/keltec/triggerpin.htm
 
1 - 6 of 6 Posts
Top