Community for Kel-Tec Shooters banner

Slip on Grip

2.4K views 8 replies 7 participants last post by  JMag1  
#1 ·
Hi

Does anyone know if the Hogue grip for the Ruger LCP will work on the P32?

I have one and want to pick up the KT .32,

Just curious.

Dave
 
#2 ·
I am 99% sure it fits. I have the P3AT (same size as LCP) & I used to have the P32. The only difference in size IIRC is the P32 is just a little bit thinner. Given the stretch fit for a slip on grip, that tiny difference wouldn't matter. (I have a Houge slip-on for my P40; it was a bear to stretch over the grip!)
 
#3 ·
It should fit. Before putting the slip-on grip on the gun, try gluing a piece of thin mouse pad material on the back half of the gun. From middle of grip around the back to middle of other side. It helps with recoil and really makes it nice for shooting. This is really good for the pocket .380 guns.
 
#5 · (Edited)
I tried the Houge and it took a small amount of cutting with an exacto knife around the mag release. Plus it doesn't quite conform tightly around the backstrap area. I also tried the Fixxxer brand which is similar to Houge with the same results.

It really comes down to personal preference and feel, and the DTOM was best for me.

Available on Amazon for $7.95
DTOM Tactical Grip Sleeve for Ruger LCP and Taurus TCP
by Don't Tread on Me Conceal and Carry Holsters

This is my Amazon review: I have tried grip sleeves from DTOM, Houge and Fixxxer for my Kel-Tec P-32. The DTOM is superior in feel and fit. There is no cutting, it fits like a glove. The others require trimming, but to be fair, they are not specifically for the P-32. The DTOM isn't either but by design it is slightly smaller, more stretchy and thicker on the sides where you see the holes. My wife and I can grip the P-32 best with the DTOM.
 

Attachments