Community for Kel-Tec Shooters banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have seen reference to the "new design hammer block" for the P3AT. I sure would appreciate some enlightenment on the subject. What does it do? Does it help? Any thoughts will be welcomed.

Clint
 

·
Registered
Joined
·
11,201 Posts
Welcome Clint.  In short it is designed to overcome user error when short stroking the trigger, or not letting it go all the way forward for a reset before pulling it the next time.  There is A LOT of more detailed info here on it.  Click on
and search for "hammer block" and you will get a lot of good info.

-Scott
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Adam, I was reading as you were posting and found many listings. My 1st. search was "redesigned the internal hammer block" and only gave one reply not much info. I guess it was TMI. Thanks again for the time to post.

Clint
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top