Community for Kel-Tec Shooters banner
1 - 12 of 12 Posts

·
Registered
Joined
·
475 Posts
Discussion Starter · #1 ·
Now that I have the RDB in my hot little hands it looks like it would be easy for someone to make a grip plug for the bottom of the grip to use that space for storage.
 

·
Registered
Joined
·
475 Posts
Discussion Starter · #3 ·
I did some quick measurements and the cavities in both the AR A2 grip and the RDB grip are similar. The AR is rounded and the RDB is rectangular but the length and width of each are close to each other.

So, anyone have an AR grip plug they can shove into the RDB to see how it fits? It should fit good but the ends won't be water tight because of the sharp corners of the RDB. Someone please give it a try.
 

·
Registered
Joined
·
162 Posts
There's one on Thingiverse since Nov 2019:

I do not like the bottom, if sighting in the bottom will not fit flat, I like my $12 one I found to fit.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top