Community for Kel-Tec Shooters banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Here is a simple and nice looking mod that all work on versions of the RDB. It is especially a pleasing and useful mod if you are using the standard factory hand guards and you are not adding addition picatinny rails on the sides. You can go from this….
Wood Water Font Rectangle Metal

…to this in a few seconds for less than five bucks.
Wood Font Metal Rectangle Plucked string instruments

Here is what you need that you can pick up at any hardware, big box store or your favorite on line store.
8 - 8mm cap x 6mm stem width (¼) x 6mm stem width


Once you have the necessary hole plugs, it is a simple thing to press them into each of the large screw holes on your RBD’s hand guard. They fit nice and tight but are still easy enough to remove if you need to do at a later time.
 
1 - 1 of 1 Posts
Top