Community for Kel-Tec Shooters banner
1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hi all-

Had a few quirks while shooting my new P3AT a few weeks ago.  A couple of you were kind enough to make some suggestions.  When breaking the pistol down to check it over and fluff it a bit, I noticed the recoil springs were slightly bent.  This is after a total of 100 rounds fired.  I didn't notice the bend when initially cleaning it after purchase.

http://mysite.verizon.net/resru01v/

I don't know if this is even a problem.  But I am curious about just what caused it.

I've never seen this on any other pistols I've owned.  Should it be considered normal for the P3AT?

Thanks in advance.

Mac
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top