Community for Kel-Tec Shooters banner
1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Seen this question asked in multiple forums so thought I'd share it here as well. Looking down into the receiver where the MAC flange is it is connected with a rivet. Where the MAC flange's wings start on both sides there is a small divet where you dremel across and notch the left side
Automotive tire Wood Automotive wheel system Machine Gas
Automotive tire Wood Automotive wheel system Rim Automotive design
Textile Sleeve Wood Grey Denim
 

·
Registered
Joined
·
6,983 Posts
I'm not sure I follow what it is you're demonstrating here. Is this for an aftermarket trigger install or something?
 
1 - 3 of 3 Posts
Top