Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

· Registered
10 Posts
Discussion Starter · #1 ·
I just added a left side belt clip to my new P3AT & had a small problem. Driving out the original frame pin was extremely difficult. I used the sorrect size roll pin punch but had to use A LOT of force. The original pin is now mangled beyond ever being usable. I was concerned about the frame being damaged but with a meticulous inspection using a magnifying glass I could find no damage. I cleaned up the pin-hole and the clip pin tapped right in. Does anyone know if this is normal? Everything seems fine and I will test fire at the range tomorrow while continuing the break in process. Thanks in advance for your input. RZ
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.