Community for Kel-Tec Shooters banner

41 - 56 of 56 Posts

·
Registered
Joined
·
399 Posts

·
Registered
Joined
·
958 Posts
I am going by my acss 22lr. When I put it on certain rifles it would run out of vertical moa. If I put regular scope no problem . It must be an acss thing.
 

·
Registered
Joined
·
33 Posts
I am going by my acss 22lr. When I put it on certain rifles it would run out of vertical moa. If I put regular scope no problem . It must be an acss thing.
That makes sense for 22lr. Depending on what distance you're zeroing at and the velocity of the round, the optic may not have enough elevation adjustment to get it to zero.
 

·
Registered
Joined
·
399 Posts
Soft touch is very general. basically any elastic covered switch.
Did you get one?
Review?
Can we get a view of the unlit reticle?
It feels like very hard plastic..
I did get one.

Eye relief is more 2.5 inches than 3.5 inches.
Feels as sturdy of a device as my Burris Ar332
Comes with the mount built in. Other mounts can't be used on this (like getting an acog qd mount like I did on my Burris)

Screws to attach to the rail are on the right side..so..Left handed charging handles dont cause the buyer to bang up their knuckles.

I like the reticle..Windage and elevation requires a flat head screwdriver

Weight is 16 oz

Is there anything else?
20201204_074220.jpg
 

·
Premium Member
Joined
·
2,545 Posts
Yea, show it on an RDB. And do a drop test.
 

·
Premium Member
Joined
·
2,545 Posts
One thing I like about this scope, besides the obviously well protected turrets, is there isn't any front end sling trap.
Just kidding about the drop. But if you do, don't drop an RDB. I don't think it can take it.
 
41 - 56 of 56 Posts
Top