Community for Kel-Tec Shooters banner
1 - 9 of 9 Posts

·
Registered
Joined
·
562 Posts
Discussion Starter · #1 ·
Are the P11 and P40 firing pins the same part?
 

·
Administrator
Joined
·
32,246 Posts
Yes, only the slide and barrel differ.
 

·
Registered
Joined
·
562 Posts
Discussion Starter · #3 ·
Ha. I guess I could have disassembled both and found out myself.
 

·
Registered
Joined
·
4,827 Posts

·
Registered
Joined
·
4,827 Posts

·
Premium Member
Joined
·
15,000 Posts
I think the guide rod for the P-40 is a tish longer than the P-11 rod. Not sure about the springs.
 

·
Administrator
Joined
·
32,246 Posts
Slightly longer (metal) rod, stronger springs... same firing pin, which was the question.
 

·
Registered
Joined
·
562 Posts
Discussion Starter · #9 ·
I think the guide rod for the P-40 is a tish longer than the P-11 rod. Not sure about the springs.

The P40 guiderod is roughly 1/8" longer. The springs are nowhere being close.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top