Community for Kel-Tec Shooters banner
1 - 9 of 9 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #1 ·
Hello everyone!

I've been a long-time gun owner and have pistols/long guns with calibers ranging from 223 to bmg. I FINALLY decided to get my ccw and bought a P3AT.

They were all wrong, all of the nay-sayers b*tching about ftf and fte problems. I knew the problems before I bought the kt and knew I needed to f&b it.

It took me a few hours to process the kt and I only used 400 grit sandpaper and a jewler's file figuring I'll polish with a dremel after the 200 round breakin.

Long story short was: 50 rounds 95 grain ammo and not ONE failure. I was expecting the worse. My new Glock 23 had one fte though. Accuracy was pretty good condsidering I could bearly see the sights.

I guess you get out of these what you put into it. It will only get better. Finger extender came in today and laser is on the way. I'm impressed and confident it will do the job when needed.

Laters
Bit
 

·
Administrator
Joined
·
32,240 Posts
F & B is a great way to get to know your new little friend. Welcome to ktog. 8)
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top