[brett_f]

I think the answer is yes, but I want to be sure. Can anyone help me out?

Are the extractors on the P3AT and PF9 identical and interchangeable?

Thanks!

-Brett

 

[brett_f]

Well. Looks like we don't know? I'll try to call KT today and ask. Then, I'll post the answer for everyone.

 

[TxCajun]

Probably not the same. More likely, the same as the P32, which is different from the PF9 according to this thead:

This is the email they sent me:

According to our Engineering Department, it is correct. There have not been any changes to this part in quite some time. Hope this helps!

Went to the range today and spoke to a retired gun shop owner. Said customer service may have sent me an extractor for a P32. Went home and checked. Sure enough the extractor cut at an angle matched perfectly with the one in my P-32. Called the factory, explained the problem and was told they would mail me a PF-9 extractor kit, today. If I end-up getting the correct kit I will be pleased. We'll see.

http://www.thektog.org/forum/showthread.php?t=248952

 

[brett_f]

Talked to Kel Tec today. The extractor on the P3AT and PF9 are identical.

Actually, so are the extractor spring, screw, and firing pin spring. The firing pins are different but the springs are identical.

Anyway, just thought I would update everyone.

 

[dracer]

good to know thanks