Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

·
Registered
Joined
·
898 Posts
Discussion Starter · #1 ·
Hi,

  Circumstances have changed my EDC P3AT from my HC P3AT, without an ArmaLaser attached, to my what was my practice/training P3AT with an ArmaLaser. Problem is/was that the draw from the Nemesis holster was not at all smooth because of the screw heads snagging on the inside holster seam. This was definitely not a good thing.  :( I first tried Duct Tape to remedy the situation but that worked with mixed results. Problem has been remedied to my satisfaction by cutting two panels from the cover of a Day Timer.  The cover material is very thin, smooth and cut properly covers the seams that matter. Vole! My gun now draws smoothly from my Nemesis holster.  :)

 



Take care...
 

·
Registered
Joined
·
5,606 Posts
Nice job Bill. A little creativity goes a long way when it comes to making these little guns work with everything. Glad you got the problem fixed and now have a smooth draw.
 
1 - 2 of 2 Posts
Top