Community for Kel-Tec Shooters banner
1 - 6 of 6 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter · #1 · (Edited)
Took my beloved P32 to the range and after several rounds the trigger started slipping allowing the hammer to slip off or not catching it at all causing the trigger to move all the way back while not rotating the hammer.

What's the fix?

ETA: I've got about 1200 rds through the gun.
 

·
Registered
Joined
·
38 Posts
Discussion Starter · #3 ·
CJ, I just tried your link but my Avast blocked it and said it's got a malware infection. Mind checking it before I try to go there again? If you're clean I can report it as a false positive.
 

·
Registered
Joined
·
478 Posts
CJ, I just tried your link but my Avast blocked it and said it's got a malware infection. Mind checking it before I try to go there again? If you're clean I can report it as a false positive.
Avast started kicking back on that site some time last year...previously
I was able to navigate it. Apparently bad69 got some bad code inserted.

Any chance your trigger bar could have worn enough to cause the problem?
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top