Community for Kel-Tec Shooters banner
1 - 5 of 5 Posts

·
Registered
Joined
·
263 Posts
Discussion Starter · #1 ·
I bought a 10 round mag as one of my spare mags when I got my P32. I'm sure I tried it at the range and didn't have any problems. I decided not to use it because I was carrying in a Fobus paddle holster at the time and the bottom of the mag printed thru most of my wardrobe. I'm now using IWB and decided to try the 10 round mag again. So I took it to the range and and after firing two rounds the follower stuck in the mag. When I got home I took it apart and the only thing I could see was a small ledge where the plastic part of the sleeve/mag met the metal part. I removed the ledge with emory paper and will try the mag again next week. Has anyone experienced problems with their 10 rounders? Should I just stick with the 8 round extended mag?
 

Attachments

·
Registered
Joined
·
115 Posts
I have an extended 10 round mag but it is currently with my gun in for repair at KT. When I get it and my gun back I will do some testing for you and report the results. It is a used mag that has been broken in. Not sure if that will make a difference or not. Only function testing will tell.
 

·
Registered
Joined
·
263 Posts
Discussion Starter · #4 ·
Thanks C-Ration. I neglected to report back to this forum that after sanding the inside of the mag where the metal sidewall meets the plastic base extension the mag feed without sticking. :D
 

Attachments

1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top