Community for Kel-Tec Shooters banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
While taking my pistol down for cleaning I seem to have moved the spring. The frame is poked out from the slide. I tried moving the spring around to see if I could get it to seat, but no luck. I put the take down pin back in and the spring seems to be holding it in place, even made a click, but the plastic frame is bowed out and will possibly crack, or at least let trash in. I had that happen with my P32, but it quickly corrected itself. Nothing I do seems to make the P-3AT reset. Help, please. Wade
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #5 ·
Had to make an L shaped tool, but no big problems. Got it back together, but I didn't take it completely apart, just moved the front part up and put the spring in where it was supposed to be. Then replaced the two pins. I'll test fire it tomorrow. Thanks again for your help. Wade
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top