Community for Kel-Tec Shooters banner

1 - 5 of 5 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I recently purchased a pf9 and on my first trip to the range i was having Failure to Extract probs. I was getting so upset that i almost sent it to kt until someone told me to make sure the extractor screw was tight. Sure enough it was loose. I couldn't believe something so simple as a screw not being tight solved my fte problems completely. Thanks KTOG!!!. 200+ rounds down the pipe with no probs. Stay safe......:):D
 

·
Administrator
Joined
·
31,982 Posts
Good deal. If you hven't already, back the screw out a few turns and apply a drop of blue locktite, then re-tighten it. You should be good to go. :cool:
 

·
Registered
Joined
·
589 Posts
I recently purchased a pf9 and on my first trip to the range i was having Failure to Extract probs. I was getting so upset that i almost sent it to kt until someone told me to make sure the extractor screw was tight. Sure enough it was loose. I couldn't believe something so simple as a screw not being tight solved my fte problems completely. Thanks KTOG!!!. 200+ rounds down the pipe with no probs. Stay safe......:):D
Good deal, glad it was that simple, lots of them are not.
 
1 - 5 of 5 Posts
Top