Community for Kel-Tec Shooters banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Hi, I'm new to the forum and new to Kel-tec. I just boughty a HC p-3at with a J2*** serial number. I am reading a lot of bad things on here with the J serial numbers. I caled kel-tec and the lady says there are no problems with the J serial numbers and that these are the newest ones on the market. so what I am asking from the members of KTOG is a list of things I need to look out for and how to correct them. Before anyone asks, no, I have not shot it yet. Life is really busy right now and it will be a few weeks before I can send some lead out of it. Until then I'll keep carrying the g-27. Thanks in advance for the help.
 
G

·
Discussion Starter · #3 ·
DWB... Glad to have you here.

A far as problems to look for......I would suggest you don't just yet. If you look hard enough, you find something not there.

Be sure to check out the teckwerks section and the fluff and buff BEFORE you shoot.

http://1bad69.com/keltec/newgunprep.htm

The link above will lead you to a general NEW GUN PREP page, with a link to the detailed fluff and buff link below:

http://www.goldenloki.com/guns/keltec/prep.htm

Shoot safely and have fun!

POst a range reprt when you get a chance.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top