Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

·
Registered
Joined
·
115 Posts
Discussion Starter · #1 ·
I just installed my NAA MZ-FPK Finger Extension Base Plate. I noticed that the plate does not line up with the hole. The plate does still fit on the mag firmly. Will the hole not lining up with the release button be a problem? If so, I will do the fix that I found on this site after doing a search.
 

·
Premium Member
Joined
·
1,830 Posts
The extension could get knocked off if the pin doesn't fit in the hole. If that happens all the stuff in the mag will fall out. Not good under life threatening conditions!

This is how to correct the situation:
http://www.geocities.com/PocketGuns/P32ext.html
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top