Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
Only had this since the 18th. Here's a before and after so far.

Added a MagPul AFG, modified buttstock, Vortex Sparc 2, single point sling and attachment. I can get 4 different positions. I found a Tapco polymer tube at work. Chopped it down and filed the hell out of the inside to get it to fit over the buffer tube.

I think I will make another attempt with a shorter pin so I don't have to chop up a stock. But I wanted to retain the original pin if I wanted to put the old stock back on.

I'm torn between ordering the MI mount or just a QD mount for the Sparc 2.


1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.