Community for Kel-Tec Shooters banner
1 - 5 of 5 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter · #1 · (Edited)
Well I must say I am pretty impressed with the CMR-30 I got. It's usually a roll of the dice if you are gonna get a good shooter or have to do some work on a keltec to make it a good shooter but this one out of the box did very well.

Started with some CCI 35 gr 22 Mag suppressed with my Gemtech 9mm Suppressor. Have to say it was very hearing friendly.

Removed the suppressor and started shooting some cheap Armscor and it had two failures to pick up the round and chamber but not the guns fault you could tell that the round was almost a dud it was weak and barely ejected the brass. Well that only happen two times and the rest were great.

Also setup up some new steel I just got from ebay.

Here are some videos and pics. If you listen carefully you can hear the brass hit my truck. LOL

https://youtu.be/ulK98bu_9Z8

https://youtu.be/tIiqxNG4uig








.
 

·
Registered
Joined
·
4,050 Posts
I got one too! 75 rounds, almost perfect with CCI. The exception being during the mag swap, I couldn't get the bolt to release on a fresh mag.
I was pretty happy with accuracy at 25 yards with iron sights. Can't wait for red dot or scope...
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top