Community for Kel-Tec Shooters banner

1 - 2 of 2 Posts

·
Registered
Joined
·
174 Posts
Discussion Starter #1
The assembly pin has started to back out from my PF9 every twenty rounds or so with the resultant FTF. Kel Tec tech support is sending out a newly modified assembly pin with a deeper groove in the bottom. Aside from this little hitch, I have put over seven hundred rounds through the PF9 over the last three months with excellent reliability.
 

·
Registered
Joined
·
5,203 Posts
KT Service actually said they're now making the cut deeper than they have been?
 
1 - 2 of 2 Posts
Top