Community for Kel-Tec Shooters banner

1 - 9 of 9 Posts

·
Registered
Joined
·
72 Posts
Neither would be of help to load the PMR-30 mags. Because of the unique loading position of the cartridge as its inserted into the magazine, none of the assists on the market works. The cartridge is placed halfway back at the top of the mag, then pressed down to be inserted past the lips, then pushed to the rear. After every 5 or so are loaded, a good rap of the rear of the mag on a firm surface helps seat the cartridges appropriately so all 30 will load with ease. To do this takes practice,and if not loaded correctly, will cause failure to feed issues, and only 23 or so rounds will seem to fit the mag.
 

·
Registered
Joined
·
111 Posts
Discussion Starter #5
I left the mags loaded for a couple of weeks to "weaken" the springs and now I can fully load all 30 in every one of them. Hope that works for you as well!
 

·
Premium Member
Joined
·
15,000 Posts
Looks like you use it to push down the mag follower, and then each loaded round, as you insert the next round.
You push it down, then slide the new round in.

I think.
 

·
Registered
Joined
·
2,095 Posts
Looks like it would get in the way of the round you are trying to put in..
 
1 - 9 of 9 Posts
Top