Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9,059 Posts
Looking at the manual it looks like part 403 (locknut) has backed off or the barrel is loosening in the part 102 (hinge).

I haven't had a plastic Subbie since '08 but that's my best guess looking at the diagram. If 403 doesn't tighten up my next step would be a call to KT service.

It kinda sounds like the barrel moving a bit front to rear & that would not be a good thing.
 

·
Registered
Joined
·
9,059 Posts
If it's like the Gen1 the barrel is molded into the plastic hinge block. I'd not take a chance. A call to Kel Tec about the loose barrel on your new Sub2000 should get prompt attention & a pre paid shipping label.

Good lord! The next round down range could be accompanied by your barrel assembly. :eek:

Full disclosure, I have sent a High Point clamp on muzzle device down range.
 
1 - 2 of 2 Posts
Top