[Guest]

http://www.ameetecarms.com/store/index.php?main_page=product_info&products_i d=82
This is the supressor I orderd. I installed the crush ring correctly. However when I tigten it, all the ports are facing right. I can not get it any tighter. Any sugestions. I do not have access to a vice, and even so I'm afraid I would damage something.

 

[Whodat]

Hey U.S.Patriot,

What I did was file down the crush washer until I got the A2 close to the home position(lined up on the bottom). Take your time about it and you will get it right.  You could also add another crush washer to help out if necessary.

 

[Guest]

Thanks, just wanted some opinions before I attempted anything.

 

[ProGun3400]

What I did was file down the crush washer until I got the A2 close to the home position(lined up on the bottom). Take your time about it and you will get it right.  You could also add another crush washer to help out if necessary.

Good advice. When in doubt, always modify the cheapest, least critical part.

 

[KingTiger]

If it's not indexing correctly with the crush washer, you need to use a peel washer. It's about the same thickness, but you heat it up with a lighter & peel thin layers off until you get the suppressor in the position you want.

 

[Guest]

I just filed it, untill it lined up. Again guys thanks for the help.