Community for Kel-Tec Shooters banner

1 - 1 of 1 Posts

·
Registered
Joined
·
320 Posts
Discussion Starter #1
I broke off the metal clip on my sub extension I decided to look for a way to install it permanent to the stock. Since i already cut my extension to fit the RL sight I just needed to trim a few corners to have enough room for the bolt to come out. Here is the result.








Some of the edges look rough but I have sanded them down to smooth surface after i took the picks. I added a nylon lock nut so it doesn't get loose. So far is very solid. I can add a second bolt at the bottom if i need to but i'm going to wait after I abuse it the way it is. If it holds up good and doesn't rotate then I will keep it with one bolt.
 
1 - 1 of 1 Posts
Top