Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,435 Posts
Discussion Starter · #1 ·
My last trip to the range ended with about 3 fte out of the last 2 mags. That was after about 50 rounds. I stripped it cleaned it and lubed it. I remembered reading posts about the extractor screw working loose. I checked it and was able to tighten it almost a full turn! Yesterday I went back to the range and shot 100 WWB and about 25 AE FMJ with not one failure! I even fired my last two mags as fast as I could pull the trigger! I took it home and gave it a well deserved cleaning and lubing. I think I have a keeper!

Craig
 

·
Registered
Joined
·
5,028 Posts
IF you should every need any thing from KT, remember to get a couple extractor screws (might as well get extractro and spring too).

a drop of thread locking fluid on that screw is nice. Just don't over tighten. it is easy to strip that little of thread. the normal torque is use the short arm of the L with one finger and thumb
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top