Community for Kel-Tec Shooters banner
1 - 5 of 5 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hello, I'm a new owner of the p3at,and first time poster... I ran across a post the other night on here about turning your kel tec zipper case into a holster... Having a little sewing machine experience I thought I would give it a try, however I didn’t make it the exact same way... here are a few pics...

I did not use the trim; instead I just hemmed the top part, and then sewed the bottom
 together inside out. Since I don't plan on carrying an extra mag I just
Stuffed the this hole and sewed it together... this seemed to work very well on  
Hiding the imprint of the gun in my pocket... I also added a small loop at the top,
This helps me snug the gun into the holster.








 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top