Community for Kel-Tec Shooters banner
1 - 7 of 7 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Hello All- Does anyone know if this particular grip specifically fits the P3at? It is not listed as a compatiblity, however, I have heard that it will fit. Thank you!
 

·
Registered
Joined
·
357 Posts
I tried the Handall Jr. - it is a little big - it would slip down on the grip - had to keep moving it up every couple of mags.

I used the Handall Jr. on my carbine - and went with the "custom hand made" inner tube grip for the P-3AT.

I still have a 10,000 year supply of inner tube left over!
 

·
Registered
Joined
·
89 Posts
i did the up-side-down install per the top of the page in this link.

http://www.1bad69.com/keltec/handalljr.htm

once u get it cut to shape(make small cuts/test fit/repete) i the used one thickness of high quality 3M automotive double-sided tape on the front of the grip and multiple layers on the backstrap which acts like a recoil pad. The 3M tape will slightly enlarge the grip to "fill-out" the Houge Jr. grip and it will not slip.

then the addition of a Bersa(or other) finger mag floorplate and the gun is transformed.

there are several other links...just use the search function.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top