Community for Kel-Tec Shooters banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have two Sub2000's in G17 variety, one was stolen from my car and recovered in a creek months later, while rusty it runs great. The other was bought used and has always FTF without a magazine tap. What happens is bullet chambers fine, but first trigger pull click and nothing, if I tap the magazine and pull the trigger it fires, cycles. The gun on every round requires a tap to bang. Has anyone experienced this what part should I check?


If you have experience and can point out the step number on this guide it would be helpful and prevent a couple of extra range trips. URL="http://www.1bad69.com/keltec/DisassemblySUB2000.pdf"]http://www.1bad69.com/keltec/DisassemblySUB2000.pdf[/URL]

Thank You and this forum has very helpful information
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top