Community for Kel-Tec Shooters banner

1 - 2 of 2 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter #1
After 300 rds the hammer is showing wear.All the
way at the tip?It looks as though it barely hits the
firing pin.Also my LCP has 1200rds and shows no wear at all on hammer.How do your hammers
look??
 

·
Registered
Joined
·
4,318 Posts
It is pretty common for PF-9 hammers to show some wear and dings, since the hammer is, by necessity, somehat softer than the firing pin. Usually this appears just about the tip of the hammer and is of no real consequence. As long a the pistol continues to fire, it is fine. If, at some point, the wear concerns you, a call to Kel Tec will get you a replacement hammer assemby and replacing the hammer is pretty simple (though it does require you to remove the frame from the grip).

Jim R
 
1 - 2 of 2 Posts
Top