I received my updated hammer block for my P3AT today and had it installed in a few minutes thanks to all the advice I've found around here. Not nearly the beast I had gotten the impression it might be.
In doing a function check after reassembly I noticed a lot of clicking if I moved the trigger after the hammer went forward on a snap-cap.
I thought the source was the hammer spring contacting the hammer-block pin/spring, but the sound/crunching/clicking is coming from the trigger itself.
Any ideas what it might be?
In doing a function check after reassembly I noticed a lot of clicking if I moved the trigger after the hammer went forward on a snap-cap.
I thought the source was the hammer spring contacting the hammer-block pin/spring, but the sound/crunching/clicking is coming from the trigger itself.
Any ideas what it might be?