Community for Kel-Tec Shooters banner
1 - 1 of 7 Posts

· Registered
5,584 Posts
It looks good to me, is the HB under the spring tension? If so you should be ready to put the frame in. Wouldn't be a bad time to put a little grease on the trigger bar.

When you reinstall the frame make sure everything is in place on the frame. You will have to use a small thin tool like a small screwdriver or punch to push and hold the HB forward as you put the rear part of the frame in. It's kinda hard to explain so if you look at post #11 of this thread it should help. There are good pictures that will help.

1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.