Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,578 Posts
Discussion Starter · #1 ·
Anyone have this happen? After cleaning from my last time out I found this gouge in my slide. It does not seem to catch while racking the slide manually. I filed a little bit down flat but do not think it will be a problem.

Lower right corner.


 

·
Registered
Joined
·
5,028 Posts
Yelp.... Mine has that to :-/

It is where the trigger disconnect cam bounces as the slide goes back.

If you don't smooth it down, you will get a second ding where it bounces again

A few months back there was a photo of similar (more severe)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top