Community for Kel-Tec Shooters banner
1 - 7 of 7 Posts

8 Posts
Discussion Starter · #1 ·
I have these two pistols. Today when shooting the P3AT with gloves on, I didn't let the trigger completely reset and pulled the trigger. At that point the gun would do nothing. I Racked the slide and it ejected the new round in the chamber and chambered the next round and everything was back to normal and it fired fine. I have found that on both of these guns if you pull the trigger after it gets to the first click that this will happen. I am sure it's normal for the Gen 1's. Does anyone know if the Gen 2's are the same? If they have corrected this can the Gen 1's be retrofitted?

I have a Ruger LCP and this is not a problem with it.

1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.