Community for Kel-Tec Shooters banner
1 - 6 of 6 Posts

·
Administrator
Joined
·
32,265 Posts
Check out the pics on page 1 of the link 3wbdriver posted. You end up with a very short, 2 finger grip! Much shorter than the grip on a Glock g19. :(
 

·
Registered
Joined
·
1 Posts
I waited till I could find a g19 version I could transfer for purchase. In hindsight, it would have been cheaper to buy one local in g17 and purchase new grips from kel tec for $50.00. That's prob. the better looking route to go vs. cutting.
 

·
Premium Member
Joined
·
17,775 Posts
has anyone cut down the pistol grip on a sub 2k G17 to accomidate G19 magazines?
It's also easier to tell you if we know what generation Sub2000 you have. Gen 1 needs to be cut. Gen 2 can be done with a simple grip purchase from Kel-tec-.
 

·
Banned
Joined
·
325 Posts
My advice is, once done (as in cut) it can not be undone. Think through it very carefully before doing it. I didnt want to cut mine so I bought the g19 grip panels and made the panel switch instead.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top