Community for Kel-Tec Shooters banner
1 - 1 of 1 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
I went to the range for the first time with my P3. I freaking love it. I shot mostly at the 7 yard line and had super tight groups. I shot the first 50 through it and then cleaned it and put 100 more through it. I had 3 FTEs, but that was the Herters ammo I was using. I used PMC for the first 50 and had no problems at all.

I certainly want to paint the sights, but I still was dead on even with the stock sights.

Couple things I did notice.

The Houge grip slid down when I rammed the mag in.

The belt clip screw came loose. Gotta get some locktite on it.

The pin for the belt clip on the side opposite of the belt clip ate my hand up. I'm going to sand it to smooth it out.

There was one spot inside my gun that got kinda dinged up. I tried to take a picture, but they weren't in focus enough but the area is on the frame on the right hand side of where the hammer is. I know it's tough to explain, but there are two thick parts of the rail that are on either side of the hammer. The one on the right is chipped at the inside corner. It almost seems like the casings were hitting it when they were ejected.

Other than that- I love this gun.

I shot my buddies LCP and didn't like it. I was less accurate with it. He shot mine and tried to trade in his LCP after we got done shooting. I put my Hogue grip on his Ruger and it improved performance greatly. However, his slide lock wasn't working either. I think his cleaning skills may have had something to do with that as well. I shot about 40 rounds without the grip on my gun and was still just as accurate.

I'm sold on Kel Tecs. Can't wait to get my hands on my used PF 9.
 
1 - 1 of 1 Posts
Top