[smnel]

Hey everyone,

I finally decided to break down and get something fun. I work at a smaller gunshop and we just received a few PMR30's and I had to put my name on one. I love the feel but not sure if I have an issue or not yet....

Like a kid on Christmas morning I had to play with it, even though my private range is going through some remodeling. So, I load up the magazine as the instructions say to, and cycle the rounds out. First time I did this, no problems. I try it again and I have constant double feeds. I was thinking that the extractor wasn't pulling out the round completely so I chamber one round and it ejects no problem with the magazine removed from the PMR. Then I attempt it with an empty magazine and it looks like the round is hitting the feed lips.

Any ideas?

Thanks,
Scott

 

[haugrdr]

Shoot it...it'll act completely different I bet.

 

[rogue66]

Mine is the same. Extractors will not pull a spent round out. This guy finally got his fixed after 4 rounds at the factory. Keltec will tell you as long as it works (ejects and chambers new round) when actually firing the gun, there is no problem.


[ame="https://www.youtube.com/watch?v=JubPwoVrdss"]https://www.youtube.com/watch?v=JubPwoVrdss[/ame]

 

[Percevel]

I really am curious about this issue.

Could anyone who is having this problem please pull their barrel and slide a cartridge into the chamber with the barrel out of the gun.

Then close up photo the lip of the cartridge when the claws would reach over and grab the case.

thank you.