Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

· Registered
Joined
·
37 Posts
Discussion Starter · #1 ·
i got me a brand new p3at today and i decided to fluff and buff it some, and now i have ran into a problem with the firing pin. When you put it back in, it has a cutout, should the hammer be in that cutout or should the hammer be behind the entire pin?
 

· Registered
Joined
·
37 Posts
Discussion Starter · #3 ·
a HA!! took me a while to figure it out, but ok its supposed to go all hte way in.. now i got it. 1 thing that does concern me also is it sounds gritty sounding when you push the pin in to make sure it can move freely, is that normal on a new gun?? or could ihave possibly not gotten all hte dirt out?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top