Community for Kel-Tec Shooters banner
1 - 1 of 1 Posts

· Registered
Joined
·
832 Posts
Hard primers aren't unusual, they do reveal that you weren't working with much margin on the "soft" primers.

Could be debris in the firing pin channel. - Dis-assemble and clean.

Since you have it apart, chamfer the breech side of the firing pin hole (turn drill bit a few sizes bigger than the hole by hand), polish the outer surface of the firing pin (do not sharpen), run a drill bit in and out of the firing pin hole by hand to deburr it. Re-clean, re-assemble.

GL
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top