Extractor Screw Size?

Discussion in 'P-3AT' started by Fat_Rat, Dec 17, 2010.

  1. Fat_Rat

    Fat_Rat New Member

    23
    Dec 3, 2010
    Does anybody know what size allen wrench is needed to remove the extractor screw?  I have a new extractor,spring and screw but do not have the proper size allen  wrench.
     
  2. JFB

    JFB New Member

    Jul 25, 2005
    a 5/64" is the correct size, however a 2mm can be forced in and is much better.  Just be sure the end of the key is in good condition.  I would not use one of the ball end keys.

    KT supplied a key with my new screws. Have they quit doing so?
     

  3. Fat_Rat

    Fat_Rat New Member

    23
    Dec 3, 2010
    I guess so.  I received a free replacement ejector, spring and screw and there was no key included.  It would have been nice but I am not complaining since KT replaced the other items at no charge.
     
  4. Fat_Rat

    Fat_Rat New Member

    23
    Dec 3, 2010
    Thanks for the information JFB. The 2mm worked!