Extractor Screw question

Discussion in 'P-3AT' started by james__12345, Dec 25, 2009.

  1. james__12345

    james__12345 New Member

    165
    Dec 7, 2009
    I just got a remington gunsmith screwdriver kit for christmas (sorta cheap from walmart, but seems ok so far). Problem is, the allen head tip i need to remove the screw that holds the extractor spring is NOT in the kit. I want to go buy it seperatly, but I'm not sure what size it is. Does anyone know? Thanks.
     
  2. JFB

    JFB New Member

    Jul 25, 2005
    It is a 5/64", but a 2mm is a tight fit and some say works better.
     

  3. james__12345

    james__12345 New Member

    165
    Dec 7, 2009
    I got a small set of bosch tips containing a 5/64ths it worked but was more loose than i liked. Tried my neighbors 2mm tip (didnt know he had one before that) it almost fit but not quite didnt go deep enough but started its way in, but his wrench looked cheap and poorly ground so i bet a GOOD 2mm would be just right.
     
  4. CJP32

    CJP32 Active Member

    Jul 24, 2008
    2mm works for me.

    CJ